Programming instructions

40
3300 ICP Technician’s Handbook
4. Using the System Administration Tool, program the analog settings on
the controller. Refer to the System Administration Tool Online Help for
information.
Peripheral Cabinet
To install a peripheral cabinet:
1. Unpack, position, and ground the peripheral cabinet.
2. Check the card layout (see page 41).
3. Connect the fiber cable to the node (see page 42).
4. Check the grounding (see page 42).
5. Install the power converter (see page 43).
6. Install the peripheral interface cards (see page 44).
7. Cable the node to the MDF (see page 45).
To unpack, position, and ground the cabinet:
1. Open the peripheral cabinet carton.
2. Remove the plastic bag from the top and sides of the cabinet.
Lift the peripheral cabinet out of the carton.
3. Check the node and attached equipment for damage. Repack and
return any damaged equipment.
4. Position the node.
Tip: Verify, in the System Administration Tool, that 3300 Embedded
Analog or 3300 Expanded Analog appears as the Installed Type in
the Analog Services Unit Configuration form.
Tip: The ONS circuits provide positive disconnect for support of applications
such as door phones.
Tip: Use the LSMeasure Tool to determine the line settings for LS trunks on
an Analog Board, Universal ASU, or ASU II (see page 250).
Tip: The CX and CXi controllers do not support Peripheral Cabinets.