Programming instructions

390
3300 ICP Technician’s Handbook
AOB, add/replace 113
clock, replace 140
cover, remove/replace 100
DSP, add/replace 109
DSP, calculate usage 105
echo canceller, add 112
echo canceller, add/replace 112
embedded analog
Amphenol pinout 263
cabinet configuration 262
circuits/ports 262
pager connector 263
embedded T1/E1, add 110
FIM, add/replace 104
framer, add/replace 111
hard drive 19
hard drive, replace 127
slot locations 15
system ID, install 20
System ID, replace 133
T1/E1 combo, add/replace 111
MX/100-user
cover, install 101
MXe
AMB, replace 136
calculate DSP usage 105
clock, replace 140
cooling fan, replace 139
cover remove/replace 101
cover, install 102
DSP, add/replace 109
DSP, calculate usage 105
E2T, install 123
echo canceller, add 112
echo canceller, add/replace 112
embedded T1/E1, add 110
FIM, add/replace 104
framer, add/replace 111
hard drive, redundant, install 117
hard drive, redundant, replace 129
hard drive, single, replace 128
power supply, install 123
power supply, replace 139
rack-mount the controller 20
RAID controller 116
slot locations 16
System ID, replace 133
T1/E1 combo, add/replace 111
MXe hardware, troubleshooting 190
N
Network Services Unit. See NSU
Networking
CXi examples 323
LX, MX, CX examples 317
NSU
BRI, illustration 271
card status LEDs 348
CEPT DIP switch 272
CIM connector pinout 269
CIM LEDs 346
FIM LEDs 346
installing BRI 37
installing R2 36
installing Universal 36
L0/L1 LEDs 348
message link DIP switch 268
PRI/T1 mode connector DIP
switch 268
program IP address 88
R2, illustration 267
T1/E1 connector pin allocation 270
T1/E1 ports DIP switches defined
268
trunk type information 271
Universal, illustration 267
NSUs
BRI DIP switch settings 272
O
OPS line card 283
Peripheral Cabinet 283
OPS Manager tool 7