Programming instructions

335
Status LEDs
Power Status, Front Panel
Hard Drive Activity, Rear Panel,
Figure 84: MXe Controller — Rear Panel with Analog
Power Supply LED (page 342)
RAID Controller LEDs (page 336)
Table 92: Controller Power LED
LED Status Meaning
Green on The system successfully booted and is operating normally.
Red - two
flashes
The unit is starting up properly (see only during boot process).
Red on solid The unit has detected an error and is held in reset mode.
Red flashing The unit has detected an error and will attempt a reset.
OFF The unit is not plugged in or is faulty.
Table 93: Hard Drive Activity LED
LED Status Meaning
Off The hard drive disk is inactive.
On flashing The internal hard disk is being accessed.