Programming instructions

320
3300 ICP Technician’s Handbook
Configuration 2: One DHCP Server for Two VLANs
Table 89 below shows the DHCP settings programmed for this
configuration.
Figure 72: One DHCP Server for two VLANs - Example
Table 89: DHCP Settings Example (Configurations 2 and 3)
Setting
DHCP Server on VLAN 1 (IP: 10.10.10.2)
Scope 1 Scope 2
DHCP 10.10.10.10 to 10.10.10.100 20.20.20.10 to 20.20.20.100
Subnet 255.255.255.0 255.255.255.0
Opt. 03 10.10.10.251 20.20.20.251
Opt 125 or 43
(Rel. 7.0>)
id:ipphone.mitel.com;sw_tftp=192.168.1.2;call_srv=192.168.1.2;
vlan=1;l2p=6;dscp=46;
Opt. 128* 20.20.20.1 20.20.20.1
Opt. 129* 20.20.20.1 20.20.20.1
Opt. 130* MITEL IP PHONE MITEL IP PHONE
Opt. 132* 2 2
Opt. 133* 6 6
* Required on Release 7.0 systems to allow IP sets to upgrade to firmware that supports
options 125 and 43.