Programming instructions

319

Typical Network Configurations

Layer 2 Switch Settings (Example)

Table 87 and Table 88 below show examples of settings on a Cisco and

an HP Layer 2 switch for this example. See Figure 71 for the port numbers.

Tip: These settings also apply for the other network configuration examples.

Table 87: Cisco Layer 2 Switch Settings Example

(Configurations 1, 2 and 3)

Port Use Command

A Access port

for VLAN 1

None (by default, all ports belong to VLAN 1)

C Access port

for VLAN 2

Router(config-if)#switchport mode access

Router(config-if)#switchport access VLAN 2

E Trunk port with

Dot1q for IP

Phone

Router(config)#interface fast 0/5

Router(config-if)#switchport mode trunk

Router(config-if)#switchport trunk encapsulation dot1q

Table 88: HP Layer 2 Switch Settings Example

(Configurations 1, 2 and 3)

Port Use Command (on HP VLAN menu)

Access port for VLAN 1

VLAN 1 = untagged

VLAN 2 = NO

Access port for VLAN 2

VLAN 1 = NO

VLAN 2 = untagged

E Trunk port

VLAN 1 = untagged

VLAN 2 = tagged