Programming instructions

301
Installation Planner
DHCP Configuration Settings
Table 77: E2T Static IP Address Programming
Option Name Value Notes/Example
Name Name of E2T
Subnet Subnet of E2T Select subnet.
IP Address IP address of E2T 192.168.1.5
Protocol “BOOTP or DHCP”
Hardware Address:
Type MAC Address
Other - Type n/a
Address MAC address of controller
E2T (see the Note)
00:12:3a:4b:c5:67
Other - Address Length n/a
Client ID n/a
Note: The E2T MAC address is found on the MAC Address label on the rear
panel of the ICP. Of the three MAC Address labels on the rear panel, use the
one that refers to “E2T MAC”, “Slot 1”.
Table 78: IP Address Range (Scope) Programming
Option Name Value Notes/Example
Name of the range
Subnet System-generated
IP Range Start (see note) Start of scope 192.168.1.15
IP Range End (see note) End of scope 192.168.1.25
Protocol Select “None”, “BOOTP”,
“DHCP”, or “BOOTP or
DHCP”
Default is “BOOTP or
DHCP”
Client’s class ID must
match name
Clear checkbox.
Lease Time 2 Weeks Minimum 5 minutes.
Note: Cannot be modified once form is saved.