Programming instructions

300
3300 ICP Technician’s Handbook
Controller Configuration Settings (RTC)
Do not change these settings unless you are directed to make changes by
an RN. Unauthorized changes may prevent the system from booting up.
Table 76: Controller Configuration Settings
Prompt Value Note
boot device ata=0, 0 Boot device is Disk.
processor number 0 Not used.
host name bootHost
file name ALL platforms, after Release 6.0:
/partition1/Rtc8260
(Prior to Release 6.0:
LX/700-user: /partition1/Rtc8260
MX: /partition1/Lite200UP
100-user: /partition1/Lite8260)
Boot location and file name.
File names are
case-sensitive.
[Settings prior to Release 5.0:
250/700-user: /sysro/Rtc8260
100-user: /sysro/Lite8260]
inet on ethernet (e) default IP address:
192.168.1.2:ffffff00
IP address and subnet mask
(hex) for controller RTC.
Provided by your IT
administrator.
inet on backplane (b)
host inet (h) IP address of PC used for
software upgrades.
gateway inet (g) IP address of the default
gateway for the 3300 ICP
(must be outside the DHCP
range).
user (u) ftp
ftp password (ftp) ftp
flags (f) 0x0 Fixed IP address (0x40 used
on E2T for DHCP).
target name (n)
startup script (s)
other (o) motfcc Other device, E2T using
Network boot from.
Tip: Do not use leading zeroes in the IP addresses. For example, enter
192.168.1.2; not 192.168.001.002.