Programming instructions

17
Installation
Figure 6: Slot Locations for 100-User Controller
Read the Safety Instructions before performing the procedures in this
chapter (see “Safety Instructions” on page 3).
 Connect the installation/maintenance PC to the Controller (page 22)
 Power up the Controller (see page 22)
 Launch the System Administration Tool (see page 8)
 Complete basic programming and Data Save (see page 25)
 Establish an Ethernet connection to the Controller (see page 27)
 Set the Controller RTC IP address (see page 28)
 Program the DHCP server (see page 29)
 Configure the Layer 2 switch (see page 35)
 Install the Units (see page 36)
 Install the Telephones and peripherals (see page 51)
Power Supply
SysID
Slot 1
FIM, T1/E1, or
BRI
Slot 2
FIM, T1/E1, or
BRI
Slot 3
DSP or BRI
Slot 4
DSP
CAUTION: To prevent ESD damage to the equipment: (1)
Ensure that the system is grounded before you install a
card. (2) Whenever you handle cards, wear an anti-static
strap (always attach the wrist strap from the cabinet).
Tip: Before installing a 3300 ICP, always read the RN for the software you
are installing (see “3300 ICP Documentation” on page 9).
CAUTION: All installation, field replacement, and servicing
procedures must be carried out by service personnel who
have successfully completed the Mitel Installation and main-
tenance training course.
CAUTION: Provide a permanent ground for all controllers
and units, through the ground connection on each cabinet.