Programming instructions

15
Installation
Install Controller Components
This chapter contains instructions on how to install a 3300 ICP. For
information on upgrading and replacing components, see page 104.
In the following illustrations, the components listed in bold text are
installed in the factory (Release 7.0 and later). If you receive a
CX/CXi/MXe and those identified components are not installed, refer to
Chapter 4 on page 95 for installation instructions.
Figure 1: Slot Locations for the LX, 250, and 700-User Controllers
Figure 2: Slot Locations for the MX Controller
Tip: In the following illustrations, T1/E1 refers to Dual T1/E1 or T1/E1 Combo,
with exception of the CX/CXi controllers which support only the Combo.
Power Supply
Slot 8
DSP
Slot 7
DSP
Slot 6
Echo Canceller or
DSP
Slot 5
Echo Canceller
SysID
Slot 1
FIM, T1/E1, or
BRI
Slot 2
FIM, T1/E1, or
BRI
Slot 3
FIM, DSP, T1/E1,
or BRI
Slot 4
FIM, DSP
Power
Supply
Analog Main Board
Analog Option Board
(optional, installed on AMB)
Hard Drive
Clock Module SysID
Slot 1
FIM, T1/E1, or
BRI
Slot 2
FIM, DSP, T1/E1,
BRI
Slot 3
DSP, T1/E1, or
BRI
Slot 4
DSP