Programming instructions

227
Troubleshooting
16.After the main boot load is downloaded,
(and only when a phone in a resilient network
has homed to the wrong ICP) the phone
seeks out the IP address of its primary 3300
ICP from the DHCP ICP Redirect list of 3300
ICPs in the network.
It is possible for the phone to be redirected
and you may see this display again.
Set xx.xx.xx.xx
ICP xx.xx.xx.xx
---------------------
Set xx.xx.xx.xx
ICP xx.xx.xx.xx
17.Once communication is established, the idle
display appears on the set.
<idle in service UI>
<idle softkeys>
Table 31: IP Phone Port Access Control Sequence
Sequence Phone Display
1. Checking the L2 switch for 802.1x Port
Access Control.
Waiting for 802.1x
authentication
2. With access control, the L2 switch will
ask for user and password (unless the
data is stored in NVRAM).
PORT ACCESS CONTROL
PRESS # TO CONTINUE
-------------------------
USER (# to end)
__
-------------------------
PASSWORD (# to end)
__
3. If Port Access Control fails. Port Access Failure
REBOOTING. . .
-------------------------
Waiting for 802.1x
authentication
4. If the data exchange succeeds or if the
L2 switch does not support 802.1x Port
Access Control.
Waiting for LLDP
Table 30: IP Phone Boot Sequence (continued)
Boot Sequence Phone Display
(Page 3 of 3)