Programming instructions

173
Troubleshooting
- To reset the factory defaults, press Default, and then follow the
prompts to set and store the factory defaults and reboot the phone.
6. To exit the current menu without a reboot:
- To return to the main menu, press Yes at EXIT MENU?
- To return to the default display, press Superkey.
Configuring Hardware Components
You can configure the speed and duplex for the LAN and PC ports.
To manually configure hardware components:
1. Access the Configuration Menu (see page 171).
2. Press No until HARDWARE CONFIG? appears, and then press Yes.
MODIFY SETTINGS? appears.
3. Do one of the following and then reboot the phone:
- To modify the current hardware components, press Yes, and then
follow the prompts to modify each setting and store the changes.
- To reset the factory defaults, press Default, and then follow the
prompts to set and store the factory defaults.
4. To exit the current menu without a reboot:
- To return to the main menu, press Yes at EXIT MENU?
- To return to the default display, press Superkey.
Setting the Phone Mode
You can program the 5215 or 5220 IP Phone (Dual Mode) to use MiNET
or to work remotely using either SIP or Teleworker Solution (6010).
For SIP configuration information, refer to the 5207/5215/5220 IP Phone
Installation Guide (56006499, Rev A) packaged with the phone, and to the
5215/5220 IP Phone SIP User Guide available at www.mitel.com.
Using Tools and Features
• “Erasing the Registration PIN” on page 174
• “Pinging IP Addresses” on page 174
• “Conducting a DHCP Trace” on page 174
• “Configuring Video Conferencing Parameters” on page 175
• “Restoring Factory Default Settings” on page 176.