Programming instructions

8
3300 ICP Technician’s Handbook
Launching the Programming Tools
Embedded System Management Tools
To log into one of the ESM tools:
1. Launch a browser and go to the URL of the 3300 Controller -
https://<hostname>/main.htm (<hostname> is the name or IP address
assigned to the Controller if no DNS is available). Refer to “Setting the
Controller RTC IP address (for Release 6.0 and later)” on page 27 or
“Setting the Controller RTC IP address (prior to Release 6.0)” on
page 28.
2. The first time you connect, you must install the Mitel Root CA security
certificate (see “Secure Sockets Layer (SSL) and Security Certificate”
on page 236).
3. Log into the 3300 ICP ESM using the default username (system) and
password (password).
4. Click the desired Tool (Desktop, Group Administration, or System
Administration).
5. You will be prompted to install some XML Components when you log
into the System Administration Tool for the first time. At the following
prompt, "Do you wish to install or upgrade the required XML
components?", click "Install Now". The install takes less than 30
seconds and you do not need to restart your computer.
ISDN Maintenance and Administration Tool
To launch IMAT on the Installation/Maintenance PC:
• On the Start menu, point to Programs, and click IMAT.
Tip: To prevent unauthorized use, change the username and password the
first time you log in.
Tip: Your PC must have the same subnet address as the RTC IP (for
example, 192.168.1.x) to launch ESM.
The system will allow up to 5 System Administration Tool users, 5 Group
Administration Tool users, and 10 Desktop Tool users at one time.
The System Administration Tool will temporarily lock you out for 15 minutes
after three consecutive attempts to log in have failed.