Programming instructions

161
Upgrades and FRUs
3. In the All forms (alphabetical) list, click Maintenance Commands.
4. Enter STATE <PLID of the card> to verify that the trunks associated
with the R2 channels are all in IDLE state.
Next: After installing the R2 card, go back to “Install the Interface
Assemblies” on page 49.
Install SUPERSET HUB FRUs
Installing a Fiber Interface Module
To install a FIM in a SUPERSET HUB:
1. Power down the SUPERSET HUB unit by disconnecting the power
cord.
2. Disconnect the fiber optic cables from the fiber interface module.
3. Remove the two screws which secure the FIM to the unit and remove
the FIM.
4. Replace the FIM. Ensure that the edge connector on the FIM is
correctly located in the socket inside the unit.
5. Replace the two screws which secure the FIM to the unit.