Programming instructions

156
3300 ICP Technician’s Handbook
Test the PRI Card
If the installation is successful, the PRI card will boot up, configure itself
with the default database, and communicate with the system.
To test the PRI card:
1. Inspect the LEDs on the faceplate to verify that the card is functioning.
See Faceplate LEDs on page 356.
2. Log into the System Administration Tool (see page 8).
3. In the All forms (alphabetical) list, click Maintenance Commands.
4. Enter STATE <PLID of the card> to verify that the trunks associated
with the PRI channels are all in IDLE state.
Installing a Peripheral Resource Card (PRC)
Each FIM in the DSU must have a peripheral resource card (PRC) installed
above it.
To install a peripheral resource card:
1. Unpack the PRC.
2. Slide the PRC into the top of slot 1 until it connects firmly with the
backplane (see Figure 69 on page 292).
3. Fasten the PRC in place using the two screws provided, or use the
latches on the card guides.
4. If a second PRC is required, install it in the same manner in the top of
slot 6 (see Figure 69 on page 292).
Next: After installing the PRC, go back to “Install the Interface Assemblies”
on page 49.
WARNING:POWER MUST NOT BE APPLIED TO THE
PERIPHERAL CABINET WHILE YOU ARE INSTALLING THE
PERIPHERAL RESOURCE CARD.