Programming instructions

153
Upgrades and FRUs
5. Using a BNC to BNC cable, connect the Tx port on the BRI interface
assembly to the Rx port on the CEPT interface assembly.
6. Using the 44-pin D-type to Amphenol cable, connect the ISDN BRI
port on the BRI interface assembly to the distribution frame, RJ-45
patch panel, or network terminating rack. Refer to the Hardware
Technical Reference Manual for BRI Card cable pinouts.
7. Connect the BRI card to the maintenance PC (see “BRI Network
Services Unit”, Step 4, a and b on page 38).
8. On the BRI maintenance PC, program the BRI card using the VT100
emulator. See Technical Bulletin 58004741 (Basic Setup Guide for the
MC268 BRI Card) for more information.
Next: After installing the BRI card, go back to page 49.
Tip: Even though the Technical Bulletin is written for the SX-2000 system,
the parameters described are also applicable to the 3300 ICP system.
Figure 28: BRI Card Connections