Programming instructions

5
Introduction
Installation Checklist
 Obtain your options and password from Mitel OnLine
 Complete the Installation Planner Appendix (see page 295)
 Install controller hardware (see page 15)
 Connect maintenance PC to Controller (see page 22)
 Power up the Controller (see page 22)
 Launch the System Administration Tool (see page 8)
 Program the License and Options Selection (see page 25)
 Perform a DBMS Save (see page 25)
 Set the Date and Time (see page 26)
 Program the Controller modules (see page 26)
 Establish an Ethernet connection to the Controller (see page 27)
 Set the Controller RTC IP address (see page 28)
 Program the DHCP server (see page 29)
 Configure the Layer 2 switch (see page 35)
 Install NSU, ASU, Peripheral Cabinet, DSU, SUPERSET™ Hub
(page 36)
 Program Units and Modules (follows each installation procedure)
 Install Telephones (see page 51)
 Register IP Devices (see page 52)
 Program Telephones (see page 54)
 Install a DNIC Music on Hold /Paging Unit (see page 57)
 Program Trunks (see System Administration Tool OnLine Help)
 Program Automatic Route Selection (see OnLine Help)
 Program Voice Mail (see OnLine Help)
 Program Paging (see OnLine Help)
 Program Music on Hold (see OnLine Help)
 Program Automatic Call Distribution (see OnLine Help)
 Program Hotel/Motel (see OnLine Help)
 Perform a DBMS Save (see page 25)