Programming instructions

115
Upgrades and FRUs
8. Connect the other ends of the flex cable and power cable where
indicated in Figure 12. The horizontal flex cable connector is hinged:
flip up to loosen it, insert the cable, and then press down to tighten (4).
9. Replace the top cover (see page 101).
10. Power up the controller.
11. In the System Administration Tool, go the Analog Services Unit
Configuration form.
12. Select Unit 4 and click Modify.
13. Select 3300 Expanded Analog and click Save.
Figure 12: Screws and Standoffs on the Analog Option Board