Programming instructions

110
3300 ICP Technician’s Handbook
Programming the Additional Voice Mail Ports
To program the additional voice mail ports:
1. In the System Administration Tool, change the number of voice mail
ports. In the All forms (alphabetical) list, click the Voice Mail Port
Capacity form.
2. In the Voice Mail Port Assignment form, program the extension and
interconnect numbers for each new voice mail port.
3. Reboot the controller (see page 99).
Framer (Dual T1/E1, T1/E1 Combo, Quad BRI)
Embedded T1/E1 (for PRI or T1/D4) or BRI
You can add embedded T1/E1 (for PRI, T1/D4, or MSDN/DPNSS) or
embedded BRI to a controller by adding one to three framer modules (Dual
T1/E1, or Quad BRI) in the controller (see “Hardware Part Numbers” on
page 365 for the part number of the Framer Modules). The CX controller
does not support the Dual T1/E1 Framer. The BRI Framer is not supported
in North America.
Dual T1/E1 Framer
Each Dual T1/E1 Framer has 2 ports (RJ-45 connectors), each of which
can be used for T1/E1 ISDN or T1/D4. The two protocols can operate in
tandem on the same Dual T1/E1 Framer with any ISDN variant, i.e. PRI
and QSIG.
T1/D4 provides for digital E&M, digital DID, or digital CO protocols. T1/E1
ISDN provides for DMS-100, DMS-250, NI-2 (Bellcore National ISDN,
5ESS, GTD5), Euro ISDN, 4ESS, Euro-ISDN (CTR4), and QSIG
protocols.
Tip: Upgrading to embedded PRI, T1/D4, MSDN/DPNSS, or BRI requires
a minimum 300 MHz controller (see
“Upgrading to a 300 or 450 MHz
Controller”, page 102). To determine the speed of your processor, see
“Checking Controller Hardware Profile” on page 235.
Tip: The Dual T1/E1 Framer does not support XNET, Min/Max, or NFAS.