Programming instructions

100
3300 ICP Technician’s Handbook
3. Remove the controller from the rack (if applicable) and place it on a
suitable work area.
4. Remove the front faceplate (clip it off).
5. Turn the controller over gently, keeping the front panel facing forward.
6. Remove the two screws from the underside of the controller.
7. Turn the controller the right side up and rotate it until the back panel
unit is facing you.
8. Remove the two screws from the back panel.
9. Slide the cover forward until it catches, then tilt the cover up to remove.
To install the LX/700-user controller cover:
1. Turn the controller until the back panel is facing forward.
2. Lift the lock for the AC power cord and place the cover at an angle to
hook onto the back of the unit.
3. Straighten and slide the cover forward as far as it will go.
4. Secure the shell by inserting and snugly securing the two screws on
the back panel.
5. Turn the controller gently upside down.
6. Secure the screws on the bottom front of the unit.
7. Turn the controller right side up.
8. Clip on the front face-plate taking care not to damage the protruding
FIM connectors.
9. Reinstall the controller into the rack (if applicable).
10. Reconnect all cables.
11. Power on the unit.
Removing/Replacing MX/100-User Controller Cover
To remove the MX/100-user controller cover:
1. Turn off the power to the unit.
2. Disconnect all cables.
3. Remove the controller from the rack and place it on a suitable work
area.