Programming instructions

91
Software Procedures
9. Click Next to select the NT Direct Connection.
10. Select COM 1 or COM 2, and then click Next.
11. Click Finish.
12. In the Modem Properties window, select NT Direct Connection,
then click Properties.
13. Set the following parameters:
- Maximum speed: 38 400
- Check: Only connect at this speed
- Data bits: 8
- Parity: None
- Stop bits: 1
- Mode: Auto Answer
In Advanced Settings window, do the following for a direct connect
cable:
- Turn off: Error control
- Turn off: Flow Control
14. Click OK and close the Control Panel window.
Physically Connecting the PC to an NSU
• Connect an RS-232 straight DTE serial cable between the NSU’s serial
port and the PC’s serial port.
Creating a Dial-Up Network Connection on Windows 95/98
Typically, you need to follow this procedure twice to create two Dial-up
Networking connections, one for on-site direct access, and one for remote
modem access.
1. On the Start menu, point to Programs, point to Accessories, and
then click Dial-Up Connections.
2. Double-click Make New Connection.
3. Enter an appropriate name for the connection (for example, Direct for
direct connections, Remote or a customer’s name for remote
connections) and click Next.
Tip: If you are connecting through a modem, use a null modem adapter on
the NSU side.