Installation Guide

23

4.4 VerifyDeviceFunctionalityandTestNetworkCoverage 

1. CheckLEDs 
The LEDshouldbesolidwhite. Ifitis flashingorange,thefirmware isautomaticallyupgrading and
the
 LED should turn green when the upgrade is completed (normally in underthirty minutes).
Note:YourCW9166I‐MR,CW9164I‐MRmusthaveanactiveroutetotheInternettocheckandupgradeits
firmware.


2. Verify access point connectivity
Useany802.11clientdevicetoconnecttotheCW9166I‐MR,CW9164I‐MRandverifyproperconnectivityusing
theclient’swebbrowser.


3. Checknetworkcoverage 
Confirmthatyouhavegoodsignalstrengththroughoutyourcoveragearea.Youcanusethesignalstrength
meter
 onalaptop,smartphone,orotherwirelessdevice. 



5 Troubleshooting 
ReferencetheMerakiknowledgebaseathttp://meraki.com/support/knowledge_baseforadditionalinformation
and
 troubleshootingtips. 

6 Regulatory 

FCC Compliance Statement 
Thisdevicecomplieswithpart15oftheFCCrules.Operationissubjecttothefollowingtwoconditions:(1)Thisde‐ 
vicemaynotcauseharmfulinterference,and(2)thisdevicemustacceptanyinterferencereceived,including
interference
t hatmaycauseundesiredoperation. 

FCCInterference Statement 
ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,pursuanttopart15
of
 theFCCRules.Theselimitsaredesignedtoprovidereasonableprotectionagainstharmfulinterferenceina
residen
tial installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in
 accordance with the instructions, may cause harmful interference to radio communications. However,
there is no
 guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference
 to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged
 to correct the interference by one of the following measures:
      •Reorientorrelocatethereceivingantenna. 
      •Increase the separationbetweentheequipmentandreceiver. 
      •Connecttheequipmentintoanoutletonacircuitdifferentfromwhichthereceiverisconnected. 
      •Consultthedealeroranexperiencedradio/TVtechnicianfor help. 

FCCCaution 
Any changes or modifications no expressly approved by Meraki could void the user’s authority to operate this

equipment. This Transmitter must not be co‐located or operation in conjunction with any other antenna or
transmitter.


FCCRadiationExposureStatement 
ThisequipmentcomplieswithFCCradiationexposurelimitssetforthforanuncontrolledenvironment.This
equipment
 shouldbeinstalledandoperatedwithminimumdistance41cmbetweentheradiatorandyourbody.