User guide

2-42
Cisco Transport Manager Release 9.2 GateWay/CORBA User Guide and Programmer Manual
OL-20937-01
Chapter 2 NE- and CTM-Specific Details
2.2.7 Provisioning Subnetwork Connections
Use the API getAllSrcPTP/CTP/FTPForCircuitProvisioning to retrieve the possible endpoints, taking
into account the current card mode.
Note You cannot change the card mode from the CTM GateWay/CORBA interface. You cannot change the
card mode if there is a circuit on the card.
To determine whether a CE-MR-10 card is configured for Manual or Automatic mode, use the
getEquipment API, which returns the CardMode parameter.
The following layer rates are supported for CCAT circuits:
• LR_STS1_and_AU3_High_Order_VC3
• LR_STS3c_and_AU4_VC4
• LR_STS6c_and_VC4_2c
• LR_STS9c_and_VC4_3c
• LR_STS12c_and_VC4_4c
• LR_STS24c_and_VC4_8c
• LR_STS48c_and_VC4_16c
The following layer rates are supported for VCAT member circuits:
• LR_STS1_and_AU3_High_Order_VC3
• LR_STS3c_and_AU4_VC4
• LR_VT1_5_and_TU11_VC11
2.2.7.2.5 SNC Provisioning for ONS 15454 ADM-10G Cards
The ADM_10G card ports carry the OCN and GE traffic. You can provision each of the first eight ports
as 1GE port that carry GE traffic. These ports, by default, GFP-encapsulation enabled. However, if
required, you can configure them as HDLC.
CTM Gateway/CORBA can manage CCAT bidirectional SNCs with FTP termination points on
ONE_GE_PORT ports ranging from 1 to 8 in the framing protocol types previously listed.
The following table lists the supported layer rates along with their corresponding values:
Table 2-19 Layer Rates Supported by ONS 15454 ADM-10G Cards
Layer Rates Values
STS1 LR_STS1_and_AU3_High_Ord
er_VC3
STS3C LR_STS3c_and_AU4_VC4
STS6C LR_STS6c_and_VC4_2c
STS9C LR_STS9c_and_VC4_3c
STS12C LR_STS12c_and_VC4_4c
STS24C LR_STS24c_and_VC4_8c