User guide

2-41
Cisco Transport Manager Release 9.2 GateWay/CORBA User Guide and Programmer Manual
OL-20937-01
Chapter 2 NE- and CTM-Specific Details
2.2.7 Provisioning Subnetwork Connections
2.2.7.2.3 Layer Rates
CTM supports the following layer rates on E-series cards:
• LR_STS1_and_AU3_High_Order_VC3
• LR_STS3c_and_AU4_VC4
• LR_STS6c_and_VC4_2c
• LR_STS12c_and_VC4_4c
CTM supports the following layer rates on G-series cards:
• LR_STS1_and_AU3_High_Order_VC3
• LR_STS3c_and_AU4_VC4
• LR_STS6c_and_VC4_2c
• LR_STS9c_and_VC4_3c
• LR_STS12c_and_VC4_4c
• LR_STS24c_and_VC4_8c
• LR_STS48c_and_VC4_16c
CTM supports the following layer rates on ML-series cards:
• LR_STS1_and_AU3_High_Order_VC3
• LR_STS3c_and_AU4_VC4
• LR_STS6c_and_VC4_2c
• LR_STS9c_and_VC4_3c
• LR_STS12c_and_VC4_4c
• LR_STS24c_and_VC4_8c
CTM supports the following layer rates on FCMR cards:
• LR_STS1_and_AU3_High_Order_VC3
• LR_STS3c_and_AU4_VC4
CTM supports the following layer rate on CE-100T-8 and ML-100T-8 cards:
• LR_STS1_and_AU3_High_Order_VC3
2.2.7.2.4 SNC Provisioning for ONS 15454 CE-MR-10 Cards
The ONS 15454 CE-MR-10 card implements two different working modes:
• Automatic mode—Available only for ONS 15454 SONET
• Manual (or Exposed) mode—Available for ONS 15454 SONET and ONS 15454 SDH
Automatic mode is similar to the provisioning of existing ML-series cards, where FTPs must be used for
CCAT and VCAT circuit provisioning, and the FTP name is the number of the virtual back-end port.
Manual mode requires PTPs/CTPs to be specified for the aEnd and zEnd on CCAT circuits, and for
aEnd(s) and zEnd(s) on VCAT member circuits. For VCAT circuit endpoints, FTPs must be used.
Use one of the following APIs to retrieve available CTPs:
• 3.8.20 getAllSrcCTPsForVCATMemberSNCProvisioning, page 3-104
• 3.8.23 getAllDestCTPsForVCATMemberSNCProvisioning, page 3-107