User guide

A-13
Cisco Transport Manager Release 9.2 GateWay/CORBA User Guide and Programmer Manual
OL-20937-01
Appendix A Notifications, Fault Management, and Probable Cause Mapping
A.5.2 CTM GateWay/CORBA Mapping—EMS
"TIM": trace identifier mismatch (when reported as an alarm)
"TU-AIS": TU alarm indication signal
"TX_DEGRADE": transmitter degrade, including laser degrade
"TX_FAIL": transmitter failure, including laser failure
"UAT": Unavailable Time
"UNEQ": payload unequipped
"VC-AIS": VCL/VCC TP Alarm Indication Signal
"VC-RDI": VCL/VCC TP Remote Defect Indication
"VP-AIS": VPL/VPC TP Alarm Indication Signal
"VP-RDI": VPL/VPC TP Remote Defect Indication
A.5.2 CTM GateWay/CORBA Mapping—EMS
The following table lists the CTM GateWay/CORBA mapping for the EMS.
A.5.3 CTM GateWay/CORBA Mapping—MGX 8880/8850/8830
The following table lists the CTM GateWay/CORBA mapping for the MGX 8880/8850/8830.
Table A-16 CTM GateWay/CORBA Mapping for the EMS
TMF Mapping NE Native Probable Cause
EMS Loss of communication
EMS Memory automatic or manual backup failure
SECURITY_VIOLATION Maximum login attempts exceeded
EMS Partition 0...6 free disk space low
EMS Alarm resync unsuccessful
EMS Server monitor threshold crossed
Table A-17 CTM GateWay/CORBA Mapping for the MGX 8880/8850/8830
TMF Mapping NE Native Probable Cause
EMS Sync-up has not started yet
EMS Currently in sync-up
EMS Partial sync-up
EMS Sync-up failed
EMS Server in partial sync-up
EMS Server sync-up failed
Note The following EMS alarms must be cleared manually, so “isClearable” should be set to
“False” in the corresponding CTM GateWay/CORBA alarm event.
EMS FTP transfer failure
EMS FTP file size mismatch
EMS FTP transfer failed
EMS Upload file error
EMS Minus 2 trap