User guide

3-273
Cisco Transport Manager Release 9.2 GateWay/CORBA User Guide and Programmer Manual
OL-20937-01
Chapter 3 Using CTM GateWay/CORBA Interfaces
3.13.8 getTPHistoryPMData
• globaldefs::Time_T retrievalTime
ME time at which PM measurement was obtained from the ME.
• PMMeasurementList_T pmMeasurementList:
PM values.
• CTM support for PMMeasurement_T structure is as follows:
– PMParameterName_T pmParameterName
Name of the PM measure.
– PMLocation_T pmLocation
CTM supports PML_NEAR_END_RX and PML_FAR_END_RX.
– float value
Value of parameter.
– string unit
Not supported.
– string intervalStatus
CTM supports the following string values:
Valid—The PM data value is valid.
Invalid—The PM data value is invalid or unavailable.
Throws
EXCPT_NOT_IMPLEMENTED - Raised when the NMS queries historical data older than 6 hours for
15-minute buckets or 24-hour PM.
EXCPT_INTERNAL_ERROR - Raised in case of nonspecific EMS internal failure.
EXCPT_INVALID_INPUT - Raised when any input parameter is not well formed.
EXCPT_TOO_MANY_OPEN_ITERATORS - Raised when the EMS reaches the maximum number of
iterators that it can support.
LR_Section_OC48_STS48_and_RS_STM16 PMP_BBE
PMP_ES
PMP_SES
PMP_UAS
PML_NEAR_END_RX 15 min
24 hr
LR_STS3c_and_AU4_VC4 PMP_BBE
PMP_ES
PMP_SES
PMP_UAS
PML_NEAR_END_RX
PML_FAR_END_RX
15 min
24 hr
LR_VT2_and_TU12_VC12 PMP_BBE
PMP_ES
PMP_SES
PMP_UAS
PML_NEAR_END_RX
PML_FAR_END_RX
15 min
24 hr
Table 3-11 ONS 15305 and ONS 15305 CTC pmParameter Values (continued)
ONS 15305 Layer Rate pmParameterName Location Interval