User guide

3-212
Cisco Transport Manager Release 9.2 GateWay/CORBA User Guide and Programmer Manual
OL-20937-01
Chapter 3 Using CTM GateWay/CORBA Interfaces
3.13.3 setTCATPParameter
3.13.3 setTCATPParameter
Synopsis
void setTCATPParameter(in globaldefs::NamingAttributes_T tpName,
inout TCAParameters_T tcaParameters)
raises(globaldefs::ProcessingFailureException);
Description
This interface modifies the values of TCA thresholds on a TP-layer rate measurement point. This
interface can be applied to a PTP or CTP. The NMS specifies the TP and layer rate, the granularity, and
the values of one or more TCA thresholds to modify. The operation mode is best-effort. If no TCA value
is set, the default value is active.
If CTM fails to set TCA parameters, an exception is generated. A successful return of this operation
guarantees that all values are set. If a parameter fails, the remaining parameters are unchanged. CTM
does not send events or updates when TCA parameters are changed. It also does not validate the range
of PM parameter values.
The NMS always makes synchronous calls to this method.
Parameters
CTM support for TCAParameters_T structure is as follows:
• transmissionParameters::LayerRate_T layerRate
For a list of supported layer rates, see 2.2.1 Layer Rate, page 2-23.
• Granularity_T granularity
CTM supports 15 minute (15min) and 24 hour (24h).
• PMThresholdValueList_T tcaTypeValues
This is a sequence of PMThresholdValue_T. It contains the PMParameterName_T
pmParameterName field.
CTM supports the NE PM values listed in Table 3-5, Table 3-6, Ta ble 3-7 , Table 3-9, Table 3-10, and
Table 3-11.
Name Type Input/Output Description
TpName globaldefs::NamingAttributes_T In Identification of the TP for which the values of one or
more TCA parameters are set.
TcaParameters TCAParameters_T In/out List of TCA IDs and corresponding values to apply to a
specific layer rate. The settings that are actually applied
are returned in this parameter.
Table 3-5 ONS 15310 CL and ONS 15310 MA SONET TCA TP ParameterName Values
PTP or CTP pmParameterName Location Interval
LR_POS_100M
LR_POS_GIGABIT