User guide

3-200
Cisco Transport Manager Release 9.2 GateWay/CORBA User Guide and Programmer Manual
OL-20937-01
Chapter 3 Using CTM GateWay/CORBA Interfaces
3.10.16 createL2Topology
• subnetworkConnection::VCATSNCCreateDataList_T vcatSncInfoList
Supported.
createVTAggregation True or false Applicable for VC SNCs with one or more transit nodes that
do not have a VAP circuit or the existing VAP circuit is
exhausted. This parameter specifies whether to create a new
VAP circuit on the transit node(s). If the value specified is
true, a VAP circuit is created and SNC is routed using this
new VAP circuit.
If the value specified is false, a new VAP circuit is not
created.
sourceIsSTSGrroming True or false When set to true, the source drop point of the VC circuit is
STS groomed for the VAP circuit.
Note This attribute is valid only when
createVTAggregation is set to true.
Note sourceIsSTSGrooming and
destinationIsSTSGrooming cannot both be set to
true.
destinationIsSTSGrooming True or false When set to true, the destination drop point of the VT or VC
circuit is STS groomed for the VAP circuit.
Note This attribute is valid only when
createVTAggregation is set to true.
Note sourceIsSTSGrooming and
destinationIsSTSGrooming cannot both be set to
true.
vapDestination String User-specified string (ME name) representing the VAP
destination drop point.
usePortlessTransmux True or false When set to true, the portless transmux card is used for the
circuit. The NMS provides information for
portlessTransmuxMeName, portlessTransmuxSlot, and
isSourceDS3MappedSTS; otherwise, an INVALID INPUT
exception is thrown.
When set to false, the portless transmux card is not used as
the intermediate point for the end-to-end STS-1 circuit.
portlessTransmuxMeName String Not supported.
portlessTransmuxSlot /rack=1/shelf=1/slot=[1..6][12..
17]
Not supported.
isSourceDS3MappedSTS True or false Not supported.
vcatMemberId Integer from 1 to 256 Used for VCAT SNC creation, to identify every VCAT
member L1 SNC uniquely. For normal CCAT circuits, this
value is ignored if specified.
Name Value Description