User guide
3-198
Cisco Transport Manager Release 9.2 GateWay/CORBA User Guide and Programmer Manual
OL-20937-01
Chapter 3 Using CTM GateWay/CORBA Interfaces
3.10.16 createL2Topology
If the NMS specifies EFFORT_SAME_OR_WORSE or EFFORT_WHATEVER, CTM expects
the value of staticProtectionLevel to be UNPROTECTED. These values indicate that CTM must
create the PCA.
–
Reroute_T rerouteAllowed
Not supported.
–
NetworkRouted_T networkRouted
Not supported.
–
SNCType_T sncType
Not supported.
–
transmissionParameters::LayerRate_T layerRate
Supported. For a list of supported layer rates, see 2.2.1 Layer Rate, page 2-23.
• CrossConnectList_T ccInclusions
Not supported.
• ResourceList_T neTpInclusions
Supported. You must provide a list of managed element names or the PTP names at the endpoints of
the topological link. For complete manual routing, you must provide the list of all CTPs of the links
(OCH trail links, if any) to which the circuit must be routed.
• boolean fullRoute
–
Not supported.
• ResourceList_T neTpSncExclusions
Supported. CTM expects a list of ME or PTP names at the endpoints of the topological link to
exclude from the SNC route.
• globaldefs::NamingAttributesList_T aEnd
Supported. If the topology is RPR, you specify an ML-series equipment name to use to create the
L2 topology. If the topology is point-to-point, you specify the aEnd TP name. Point-to-point
topologies can be created with one endpoint on the ML-series equipment and the other endpoint on
ML-series, G-series, or OC-n equipment.
• globaldefs::NamingAttributesList_T zEnd
Supported. If the topology is RPR, you specify an ML-series equipment name to use to create the
L2 topology. If the topology is point-to-point, you specify the zEnd TP name. Point-to-point
topologies can be created with one endpoint on the ML-series equipment and the other endpoint on
ML-series, G-series, or OC-n equipment.
• globaldefs::NVSList_T additionalCreationInfo
Supported. This list can be used to provide additional parameters for SNC creation. CTM supports
the following values.