User guide

3-151
Cisco Transport Manager Release 9.2 GateWay/CORBA User Guide and Programmer Manual
OL-20937-01
Chapter 3 Using CTM GateWay/CORBA Interfaces
3.9.21 getVCATSNC
Not supported.
• VCATState_T vcatState
Supported. The state of the VCAT circuit is derived from the states of the member circuits in the
same way as it is derived for CCAT SNCs. The values supported are:
– VCATState_T.VCATS_NONEXISTENT
– VCATState_T.VCATS_PENDING
– VCATState_T.VCATS_ACTIVE
– VCATState_T.VCATS_PARTIAL
– VCATState_T.VCATS_DELETING
• globaldefs::ConnectionDirection_T direction
Supported. This field represents the direction of the VCAT and not the member L1 SNCs.
CTM supports CD_UNI (unidirectional) and CD_BI (bidirectional). Current release supports only
CD_BI.
• boolean isSymmetrical
Supported. Current release supports only symmetric VCAT SNCs.
– True if the rate/capacity is same in both directions.
– False if the rate/capacity is different in each direction.
• transmissionParameters::VCATLayerRate_T txRate
Supported. This field represents the total capacity the VCAT SNC can carry in the forward direction.
If the VCAT is symmetrical, it represents the capacity both in the forward and backward directions.
To represent the total capacity of a VCAT SNC, VCATLayerRate_T contains the following
information:
– LayerRate_T memberRate: Layer rate of the member SNCs.
– Unsigned long numberOfMembers: Number of members for the given VCAT SNC.
For a list of supported layer rates, see 2.2.1 Layer Rate, page 2-23.
• transmissionParameters::VCATLayerRate_T rxRate
Supported. This field represents the total capacity the VCAT SNC can carry in the backward
direction. If the VCAT is symmetrical, this field is ignored. For a list of supported layer rates, see
2.2.1 Layer Rate, page 2-23.
• transmissionParameters::LayerRate_T memberRate
Supported. This field represents the rate of each member circuit.
• globaldefs::NamingAttributes_T aEnd
Supported. This is an FTP representing the port at the aEnd.
• globaldefs::NamingAttributes_T zEnd
Supported. This is an FTP representing the port at the zEnd. This field is empty for open-ended
VCAT.
• SNCType_T sncType
Not supported.
• subnetworkConnection::LCASMode_T mode
Supported. CTM supports the following values: