User guide

3-57
Cisco Transport Manager Release 9.2 GateWay/CORBA User Guide and Programmer Manual
OL-20937-01
Chapter 3 Using CTM GateWay/CORBA Interfaces
3.6.1 getAllEquipment
• string installedSerialNumber
– Supported when equipment is installed.
• globaldefs::NVSList_T additionalInfo
– Supported when equipment is installed. Common Language Equipment Identification (CLEI)
code is available.
CTM support for EquipmentHolder_T is as follows:
• globaldefs::NamingAttributes_T name
– Supported. This field has three tuples: one for EMS, one for ManagedElement, and one for
EquipmentHolder name.
• string userLabel
– Not supported.
• string nativeEMSName
– Supported. The naming convention is defined in 2.2.5.7 Equipment Holder, page 2-35.
• string owner
– Not supported.
• boolean alarmReportingIndicator
– Not supported.
• EquipmentHolderType_T holderType
– Supported values are additionalHolder, rack, shelf, and slot.
– For the ONS 15600 SONET and ONS 15600 SDH, valid values are rack, shelf, slot, sub_slot,
and ppm_holder.
– For the ONS 15310 CL, ONS 15310 MA SONET, and ONS 15310 MA SDH, valid values are
rack, shelf, slot, and ppm_holder.
– For the ONS 15540 and ONS 15530, valid values are rack, shelf, slot, sub_slot, and ppm_holder.
– For the ONS 15454 SONET and ONS 15454 SDH, valid values are rack, shelf, slot,
ppm_holder, and port.
– For all equipment supporting SFP modules, valid values are rack, shelf, slot, sub_slot, and
port_holder.
– For the MGX 8880/8850/8830, valid values are rack, shelf, slot, sub_slot, and
peripheral_holder.
• globaldefs::NamingAttributes_T expectedOrInstalledEquipment
– Supported. If the slot is empty and not preprovisioned for equipment, this field is empty.
• EquipmentObjectTypeList_T acceptableEquipmentTypeList
– Supported.
– Not supported for ONS 15530 and ONS 15540.