Technical information
Table Of Contents
- 1 What is TL1?
- 2 TL1 Message Types and Examples
- 3 Connect to TL1
- 4 Log Into TL1
- 5 Command Actions and Categories
- 6 Ten Basic Commands
- 7 Log Out of TL1
- 8 Obtaining Documentation
- 9 Documentation Feedback
- 10 Cisco Product Security Overview
- 11 Obtaining Technical Assistance
- 12 Obtaining Additional Publications and Information
9
5 Command Actions and Categories
When you have connected and logged into a TL1 session, you are ready to begin issuing TL1
commands and autonomous messages. TL1 commands and autonomous messages can be used to
accomplish a variety of actions. Determining the correct command or autonomous message you need
begins with identifying what action you want to perform. The first part of every command and
autonomous message helps identify the action that command or autonomous message performs as
shown in Table 1.
Table 1 TL1 Command and Autonomous Message Actions
Commands or Autonomous
Messages That Begin With Generally Do This Command Example
ACT- Activate ACT-USER
ALW- Allow ALW-MSG-ALL
APPLY Apply APPLY
CANC (autonomous message) Report CANC (reports a cancelled session)
CANC- Cancel CANC-USER
CHG- Change CHG-ACCMD-<MOD_TACC>
CLR- Clear CLR-COND-SECU
CONN- Connect CONN-TACC-<MOD_TACC>
COPY- Copy COPY-IOSCFG
DISC- Disconnect DISC-TACC
DLT- Delete DLT-BLSR
ED- Edit/Change ED-BITS
ENT- Enter/Create ENT-BLSR
EX- Exercise EX-SW-<OCN_BLSR>
INH- Inhibit INH-MSG-ALL
INIT- Initialize INIT-SYS
OPR- Operate/Create OPR-LNK
REPT (autonomous message) Report REPT ALM ENV
RLS- Release RLS-EXT-CONT
RMV- Remove RMV-<MOD2>
RST- Restore RST-<MOD2>
RTRV- Retrieve RTRV-COND-RING
SCHED- Schedule SCHED-PMREPT-<MOD2>
SET- Set SET-ATTR-ENV
SW- Switch SW-DX-EQPT