Technical information
Table Of Contents
- 1 What is TL1?
- 2 TL1 Message Types and Examples
- 3 Connect to TL1
- 4 Log Into TL1
- 5 Command Actions and Categories
- 6 Ten Basic Commands
- 7 Log Out of TL1
- 8 Obtaining Documentation
- 9 Documentation Feedback
- 10 Cisco Product Security Overview
- 11 Obtaining Technical Assistance
- 12 Obtaining Additional Publications and Information
15
• SYNCMAP is the synchronization mapping for the DS1 facility. Only supported on ONS 15454.
• ADMSSM is the administration synchronization status message. Only supported on ONS 15454.
• PROVIDESYNC indicates whether the facility provides synchronization. Only supported on
ONS 15454.
• VTMAP is the port to VT mapping type for that particular STS. Only supported on ONS 15454.
• INHFELPBK indicates whether far end loopbacks are inhibited on the facility. Only supported on
the ONS 15454.
• PST_PSTQ is primary state.
• SSTQ is secondary state.
Response Example:
TID-000 1998-06-20 14:30:00
M 001 COMPLD
“FAC-2-1::LINECDE=AMI,FMT=ESF,LBO=0-131,TACC=8,TAPTYPE=DUAL,SOAK=52,
SOAKLEFT=12-25,SFBER=1E-4,SDBER=1E-7,NAME=\“T1 PORT\”,SYNCMSG=Y,
SENDDUS=Y,RETIME=Y,AISONLPBK=AIS_ON_LPBK_ALL,AISVONAIS=Y,AISONLOF=Y,
MODE=FDL,SYNCMAP=ASYNC,ADMSSM=STU,PROVIDESYNC=N,VTMAP=GR253,
INHFELPBK=N:OOS-AU,AINS”
;
RTRV-ALM-T1
Use the RTRV-ALM-T1 command to retrieve all alarms on a specific E1 port. The RTRV-ALM-T1
command is listed as RTRV-ALM-<MOD2ALM> in the Cisco ONS SONET TL1 Command Guide.
T1 is just one of the options you can enter. RTRV-ALM-T1 is from the Fault category.
Input Format:
RTRV-ALM-<MOD2ALM>:[<TID>]:<AID>:<CTAG>::[<NTFCNCDE>],[<CONDTYPE>],
[<SRVEFF>][,,,];
• TID is the name of the node you want to access. If you only want to query the node you connected
to leave the TID blank.
• AID is the access identifier to indicate slot and port.
• CTAG is any non-blank character series that does not have to be unique.
• NTFCNCDE is the 2-letter notification code. Values are CL (cleared), CR (critical), MJ (major),
MN (minor), NA (not alarmed), and NR (not reported).
• CONDTYPE is the alarm condition.
• SRVEFF is the effect on service caused by the alarm condition. Values are NSA (not service
affecting) or SA (service affecting).