Technical information
Table Of Contents
- 1 What is TL1?
- 2 TL1 Message Types and Examples
- 3 Connect to TL1
- 4 Log Into TL1
- 5 Command Actions and Categories
- 6 Ten Basic Commands
- 7 Log Out of TL1
- 8 Obtaining Documentation
- 9 Documentation Feedback
- 10 Cisco Product Security Overview
- 11 Obtaining Technical Assistance
- 12 Obtaining Additional Publications and Information
13
• VTMAP is the port to VT mapping type for that particular STS. Only supported on ONS 15454.
• INHFELPBK indicates whether far end loopbacks are inhibited on the facility. Only supported on
ONS 15454.
• AISONLPBK is the AIS to be sent on what type of loopback.
• CMDMDE is the command mode. Values are FRCD or NORM.
• AISVONAIS is enabled or disabled.
• AISONLOF is enabled or disabled.
• PST is primary state. Values are IS or OOS.
• SST is secondary state. Values are MT or AINS.
Input Example:
ED-T1:CISCO:FAC-2-1:1223:::LINECDE=AMI,FMT=ESF,LBO=0-131,TACC=8,
TAPTYPE=SINGLE,SOAK=10,SFBER=1E-4,SDBER=1E-6,SYNCMSG=Y,SENDDUS=Y,
RETIME=Y,NAME=“T1PORT”,MODE=FDL,SYNCMAP=ASYNC,ADMSSM=STU,
VTMAP=GR253,INHFELPBK=N,AISONLPBK=AIS_ON_LPBK_ALL,CMDMDE=CMDMDE,
AISVONAIS=Y,AISONLOF=Y:IS,AINS;
RTRV-T1
Use the RTRV-T1 command to retrieve configuration information on a DS1 port. RTRV-T1 is from
the Ports category.
Input Format:
RTRV-T1:[<TID>]:<AID>:<CTAG>[::::];
• TID is the name of the node you want to access. If you only want to query the node you connected
to leave the TID blank.
• AID is the access identifier to indicate slot and port.
• CTAG is any non-blank character series that does not have to be unique.
Input Example:
RTRV-T1:TID:FAC-2-1:1223;