Technical information
Table Of Contents
- 1 What is TL1?
- 2 TL1 Message Types and Examples
- 3 Connect to TL1
- 4 Log Into TL1
- 5 Command Actions and Categories
- 6 Ten Basic Commands
- 7 Log Out of TL1
- 8 Obtaining Documentation
- 9 Documentation Feedback
- 10 Cisco Product Security Overview
- 11 Obtaining Technical Assistance
- 12 Obtaining Additional Publications and Information
12
ED-T1
Use the ED-T1 command edits the attributes related to a DS1/T1 port. ED-T1 is from the Ports
category.
Input Format:
ED-T1:[<TID>]:<AID>:<CTAG>:::[LINECDE=<LINECDE>],[FMT=<FMT>],[LBO=<LBO>],
[TACC=<TACC>],[TAPTYPE=<TAPTYPE>],[SOAK=<SOAK>],[SFBER=<SFBER>],
[SDBER=<SDBER>],[SYNCMSG=<SYNCMSG>],[SENDDUS=<SENDDUS>],
[RETIME=<RETIME>],[NAME=<NAME>],[MODE=<MODE>],[SYNCMAP=<SYNCMAP>],
[ADMSSM=<ADMSSM>],[VTMAP=<VTMAP>],[INHFELPBK=<INHFELPBK>],
[AISONLPBK=<AISONLPBK>],[CMDMDE=<CMDMDE>],[AISVONAIS=<AISVONAIS>],
[AISONLOF=<AISONLOF>]:[<PST>[,<SST>]];
• TID is the name of the node you want to access. If you only want to query the node you connected
to leave the TID blank.
• AID is the access identifier to indicate slot and port.
• CTAG is any non-blank character series that does not have to be unique.
• LINECDE is a line code. Values are AMI or B8ZS.
• FMT is a frame format. Values are D4, ESF, or unframed.
• LBO is a line build out. Values are 0-131, 132-262, 263-393, 394-524, or 525-655.
• TACC defines the STS as a test access port with a selected unique TAP number. The TAP number
is in the range of 0, 1–999. When TACC is 0 (zero), the TAP is deleted.
• TAPTYPE is the test access point type. Values are DUAL or SINGLE.
• SOAK is IS-AINS to IS transition soak time as measured in 15 minute intervals, so a value of 4
translates to a soak time of 1 hour. The allowable range is 0–192 intervals (maximum of 48 hours).
• SFBER identifies port SFBER; valid values are 1E-3, 1E-4 or 1E-5.
• SDBER identifies port SDBER; valid values are 1E-5, 1E-6,...1E-9.
• SYNCMSG is the synchronization status message. Values are NO or YES.
• SENDDUS is the synchronization status message Don’t use for Synchronization (DUS). Optional
for ONS 15454 and ONS 15310-CL/MA. Not supported on ONS 15327.
• RETIME indicates if retiming is needed. Values are NO or YES. Optional for ONS 15454 and
ONS 15310-CL/MA. Not supported on ONS 15327.
• NAME is the name. Maximum length is 32 characters.
• MODE type of DS1MODE.
• SYNCMAP is the synchronization mapping for the DS1 facility. Only supported on ONS 15454.
• ADMSSM is the administration synchronization status message. Only supported on ONS 15454.