Specifications

1-11

Cisco Content Services Switch Getting Started Guide

OL-6711-01

Chapter 1 Booting, Logging In, and Getting Started

Using the Configuration Script

When you log in to the CSS and it does not detect an existing startup-config file,

the CSS automatically initiates the configuration script. During the running of the

configuration script, the CSS prompts you to enter the following information:

• IP address and subnet mask for circuit VLAN1 (all interfaces are assigned to

VLAN1 by default)

• IP address for the default gateway

• IP addresses for the servers

• Virtual IP address (VIP) for the content rule

Based on your entries, the configuration script allows you to create services,

owners, and content rules. For background information on configuring services,

owners, and content rules, refer to the Cisco Content Services Switch Content

Load-Balancing Configuration Guide.

To accept the script default values, press the Enter key at the prompts shown in

the configuration script. To quit the script, enter q at any prompt. If you quit

running the script, you may proceed to Chapter 2, Configuring CSS Basics, to

continue the initial setup of the CSS. For information on configuring sticky

cookies on the CSS, see Chapter 4, Configuring Sticky Cookies.

Note You may also initiate the configuration script manually by entering the script play

setup command.

To clear an existing running-config file, use the

clear running-config command

from SuperUser mode. To clear an existing startup-config file, use the

clear

startup-config

command from SuperUser mode.