Installation guide

Chapter 2 Cabling and Troubleshooting the CSS
Connecting the Power Cord
2-28
Cisco 11500 Series Content Services Switch Hardware Installation Guide
78-16421-01
3. Plug the power cord into a dedicated 3-wire grounding receptacle.
4. See the “Powering Up the CSS” section to power on the CSS.
Note The CSS 11501 power supply is autosensing for voltage and frequency, and it
requires no additional modifications.
Connecting a CSS 11503 Power Cord
The following sections provide information on:
• Connecting a CSS 11503 AC Power Cord
• Connecting a CSS 11503 DC Power Cord
Connecting a CSS 11503 AC Power Cord
To connect an AC power cord to a CSS 11503:
1. At the rear of the chassis, ensure that the CSS power switch is in the O (off)
position.
2. Plug the AC power cord connector into the CSS power connector, as shown
in Figure 2-12.