Installation Guide
Table Of Contents
- Cisco USB BLE Beacon Installation Guide
- Contents
- Preface
- Overview of Cisco USB BLE Beacon
- Installation and Initial Setup
- Prerequisites for Cisco USB BLE Beacon Installation
- Supported Hardware
- Installation Guidelines
- Installing the Cisco USB BLE Beacon
- Importing Maps from Cisco Prime Infrastructure
- Managing Cisco CMX for Cisco USB BLE Beacon Configurations
- Establishing the Connection Between Cisco CMX and Cisco DNA Spaces BLE Manager
- Configuring a Cisco USB BLE Beacon Profile
- Technical Specifications
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco USB BLE Beacon in Japan
- Canadian Compliance Statement
- Industry Canada
- This Device Meets FCC and International Guidelines for Exposure to Radio Waves
- This Device Meets the Industry Canada Guidelines for Exposure to Radio Waves
- Cet appareil est conforme aux directives internationales en matière d'exposition aux fréquences radioélectriques
- Additional Information on RF Exposure
- Declaration of Conformity Statements
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful communication. Conformément à la
réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et
d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les
risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son
gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à
l'établissement d'une communication satisfaisante.
This radio transmitter has been approved by Industry Canada to operate with the antenna types listed below
with the maximum permissible gain and required antenna impedance.
Table 6: Antenna Specifications for Module
DescriptionItem
Embedded Antenna with Omni PatterAntenna
2.4~2.5GHzFrequency Band
LinearPolarization
1.9 dBiAntenna Peak Gain
48.6%Antenna Peak Efficiency
50 ohmsAntenna Impedance
Le présent émetteur radio a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne
énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise.
Table 7: Spécifications d'antenne pour module
La descriptionDétails de l'antenne
Embedded Antenna with Omni PatterAntenna
2.4~2.5GHzFrequency Band
LinearPolarization
1.9 dBiAntenna Peak Gain
48.6%Antenna Peak Efficiency
50 ohmsAntenna Impedance
Cisco USB BLE Beacon Installation Guide
14
Declarations of Conformity and Regulatory Information
Canadian Compliance Statement