Installation Guide
Table Of Contents
- Cisco USB BLE Beacon Installation Guide
- Contents
- Preface
- Overview of Cisco USB BLE Beacon
- Installation and Initial Setup
- Prerequisites for Cisco USB BLE Beacon Installation
- Supported Hardware
- Installation Guidelines
- Installing the Cisco USB BLE Beacon
- Importing Maps from Cisco Prime Infrastructure
- Managing Cisco CMX for Cisco USB BLE Beacon Configurations
- Establishing the Connection Between Cisco CMX and Cisco DNA Spaces BLE Manager
- Configuring a Cisco USB BLE Beacon Profile
- Technical Specifications
- Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco USB BLE Beacon in Japan
- Canadian Compliance Statement
- Industry Canada
- This Device Meets FCC and International Guidelines for Exposure to Radio Waves
- This Device Meets the Industry Canada Guidelines for Exposure to Radio Waves
- Cet appareil est conforme aux directives internationales en matière d'exposition aux fréquences radioélectriques
- Additional Information on RF Exposure
- Declaration of Conformity Statements
CHAPTER 3
Technical Specifications
This chapter contains information about the technical specifications of the Cisco USB BLE Beacon.
• AIR-BLE-USB Technical Specifications, on page 9
• Performance and Scale Requirements, on page 10
AIR-BLE-USB Technical Specifications
Table 4: Technical Specifications
4.2BLE Standard
5 dBmMaximum Transmit power
-20° to +50°C (-4° to 122°F)Operating Temperature
10% to 90% (noncondensing)Operating Humidity
-30° to 70°C (-22° to 158°F)Non-Operation Temperature
3000 meters (9850 ft)Operation Altitude
0.085 WSystem Power
0.68 x 0.36 x 2.2 inches (17.2 x 9.0 x 55.8 mm)Dimensions (H x W x L)
Cisco USB BLE Beacon can be ordered in pack of 10 or pack of 50. You must have Cisco DNA Spaces ACT
license to manage Cisco BLE USB Beacon from the Cisco DNA Spaces BLE Manager GUI.
If you already have Cisco DNA Spaces ACT license, no additional licensing is required. However, if you do
not have a Cisco DNA Spaces ACT license for the AP that a Cisco USB BLE Beacon will be placed in, a
license is required.
Note
Cisco USB BLE Beacon Installation Guide
9