Datasheet
Table Of Contents
- Regulatory Compliance and Safety Information for the Cisco Secure ACS Solution Engine Release 4.0
- Documentation Road Map
- General Precautions
- Maintaining Safety with Electricity
- Preparing Your Site for Installation
- Regulatory Standards Compliance
- Safety Information
- Statement 1-Power Disconnection Warning
- Statement 12-Power Supply Disconnection Warning
- Statement 19-TN Power Warning
- Statement 22-SELV Circuit Warning
- Statement 88-Service Personnel Warning
- Statement 106-More Than One Power Cord
- Statement 117-Safety Cover Requirement
- Statement 119-Unit Short Circuit Protection
- Statement 12-Power Supply Disconnection Warning
- Statement 331-Power Supply Installation Warning
- Statement 1001-Work During Lightning Activity
- Statement 1004-Installation Instructions
- Statement 1005-Circuit Breaker
- Statement 1006-Chassis Warning for Rack-Mounting and Servicing
- Statement 1015-Battery Handling
- Statement 1041-Disconnecting Telephone-Network Cables
- Statement 1064-Grounded Equipment
- Statement 1074-Comply with Local and National Electrical Codes
- Statement 1017-Restricted Area
- Statement 1019-Main Disconnecting Device
- Statement 1021-SELV Circuit
- Statement 1024-Ground Conductor
- Statement 1028-More Than One Power Supply
- Statement 1029-Blank Faceplates and Cover Panels
- Statement 1030-Equipment Installation
- Statement 1040-Product Disposal
- Obtaining Documentation
- Documentation Feedback
- Cisco Product Security Overview
- Obtaining Technical Assistance
- Obtaining Additional Publications and Information
13
Regulatory Compliance and Safety Information for the Cisco Secure ACS Solution Engine Release 4.0
78-17259-02
Safety Information
Korea-Class A
This device is registered for EMC requirements for industrial use. The seller or
buyer should be aware of this. If this type was sold or purchased by mistake, it
should be replaced with a residential-use type.
Safety Information
This section includes translations in multiple languages of the warnings that
might appear in the Cisco Secure SE 1113 product documents. Before working on
equipment, be aware of the hazards involved with electrical circuitry and standard
safety practices to prevent accidents.
Caution In Line Power circuits provide current through the communication cable. Use the
Cisco-provided cable or a minimum 24 AWG cable.
Caution Only use the Cisco-specified power supply. Refer to the installation manual
provided with the product.