User Manual
Table Of Contents
- Cisco Unified IP Conference Phone 8831 and 8831NR User Guide for Cisco Unified Communications Manager 10.0
- Contents
- Preface
- Features of Your Cisco Unified IP Conference Phone
- Applications
- Contacts
- Messages
- Calling Features
- Softkey Feature Map
- Answer
- Call Back
- Call Forward
- Call Park
- Call Pickup
- cBarge
- Conference
- Divert
- Do Not Disturb
- Enhanced Room Coverage
- Cisco Extension Mobility
- Hold
- Hold Reversion
- Meet Me Conference
- Mobile Connect
- Monitoring and Recording
- Multiple Calls per Line
- Mute
- On-Hook Dialing
- Plus Dialing
- Privacy
- Quality Reporting Tool
- Redial
- Shared Lines
- Speed Dial
- Transfer
- Cisco WebDialer
- Sign In to the Cisco Unified Communications Self Care Portal
- Additional Options
- Troubleshooting
- Cisco One-Year Limited Hardware Warranty Terms
Power Off the Wireless Microphone
You should turn off the wireless microphone when you do not need it, to preserve battery life.
Procedure
Step 1
Press and hold the Mute button for 10 seconds.
Step 2
Release the button when the LED turns red.
Recharge the Wireless Microphone Battery
You can only charge the wireless microphone battery in the charger. You cannot use the wireless microphone
when it is in the charger.
While the battery is charging, the LED lights red. When the battery is fully charged, the LED lights green.
When you remove the wireless microphone from the charger, the microphone automatically turns on and tries
to connect to the base. If the microphone is not paired, you need to pair the microphone.
Procedure
Place the microphone in the charger. The microphone automatically unlinks from the base and turns off.
General IP Phone Information
Power-Saving Mode
Your conference station supports the Cisco EnergyWise (EW) program. Your system administrator sets up
sleep (power down) and wake (power up) times for your conference station to save energy. In the sleep state,
the LED for the sound base Mute button becomes solid gray, and the DCU powers off.
Ten minutes before the scheduled sleep time, you receive a message that the conference station will power
down at a specific time. If the power-saving mode is enabled by your system administrator, you hear your
ringtone play. The ringtone plays according to the following schedule:
•
At 10 minutes before power down, the ringtone plays four times
•
At 7 minutes before power down, the ringtone plays four times
•
At 4 minutes before power down, the ringtone plays four times
•
At 30 seconds before power down, the ringtone plays 15 times or until the phone powers down
If your conference station is inactive (idle) at the sleep time, it powers down. If your conference station is
active (for example, on a call), it waits until it has been inactive for a period of time before removing power.
Cisco Unified IP Conference Phone 8831 and 8831NR User Guide for Cisco Unified Communications Manager
10.0
20
Features of Your Cisco Unified IP Conference Phone
Power Off the Wireless Microphone