Specifications

4-20
Cisco Internet Streamer CDS 2.0-2.3 Software Configuration Guide
OL-13493-04
Chapter 4 Configuring Devices
Configuring the Service Engine
Caution The maximum file size supported is 2 GB. Files that exceed this size limit are not supported for ICAP
processing.
To configure ICAP settings, do the following:
Step 1 Choose Devices > Devices > Service Control > ICAP. The ICAP page is displayed (Figure 4-12).
Figure 4-12 ICAP Page
Step 2
Check the Enable apply to rules-template check box, if you want to apply ICAP processing only to the
requests that match the use-icap-service rule from the Service Rules page.
Step 3 Check the Append X-Client-IP headers check box to add an X-client-IP header for ICAP processing
of HTTP requests.
Step 4 Check the Append X-Server-IP headers check box to add an X-server-IP header for ICAP processing.
Step 5 Click Submit to save the settings.
Step 6 Choose Devices > Devices > Service Control > ICAP Services. The ICAP Services Table is displayed.
Step 7 Aggregate Settings is set to Yes by default. If this SE belongs to a device group, and the settings have
not been configured using the device group, you can enter the settings and they will apply to the device
group as well.
If the settings are previously configured through the device group, the current configuration is displayed
for view only. New settings must be configured through the associated device group.
If you want to configure settings for this SE only, and override the device group settings on this SE, set
Aggregate Settings to No.
If you remove all device group settings, all device settings displayed with Aggregate Settings enabled
are removed as well.
Note The last configuration submitted for the device, whether it is the device group configuration or
the individual device configuration, is the configuration the device uses.