Specifications

4-13
Cisco Internet Streamer CDS 2.0-2.3 Software Configuration Guide
OL-13493-04
Chapter 4 Configuring Devices
Configuring the Service Engine
Figure 4-9 Replication Scheduled Bandwidth Table Page
Step 2
Aggregate Settings is set to Ye s by default. If this SE belongs to a device group, and the settings have
not been configured using the device group, you can enter the settings and they will apply to the device
group as well.
If the settings are previously configured through the device group, the current configuration is displayed
for view only. New settings must be configured through the associated device group.
If you want to configure settings for this SE only, and override the device group settings on this SE, set
Aggregate Settings to No.
If you remove all device group settings, all device settings displayed with Aggregate Settings enabled
are removed as well.
Note The last configuration submitted for the device, whether it is the device group configuration or
the individual device configuration, is the configuration the device uses.
Step 3 Click the Create New icon in the task bar. The Replication Scheduled Bandwidth page is displayed
(Figure 4-10).
To edit a scheduled bandwidth, click the Edit icon next to the scheduled bandwidth you want to edit.