Specifications

4-10
Cisco Internet Streamer CDS 2.0-2.3 Software Configuration Guide
OL-13493-04
Chapter 4 Configuring Devices
Configuring the Service Engine
• Through the device Assignment page
• Through the Device home page, if the device group is a baseline group
To assign devices to device groups through the Assignment page, do the following:
Step 1 Choose Devices > Devices, and click the Edit icon next to the device you want to assign.
Step 2 Click Show All, and then click Assignments > Device Groups. The Assignment page is displayed
(Figure 4-7).
Figure 4-7 Assignment Page
Step 3
Choose Assignments > Device Groups. The Device Group Table page is displayed with all of the
configured device groups listed.
Step 4 Click the Assign icon (blue cross mark) next to the device group you want to assign to this SE.
Alternatively, click the Assign All Device Groups icon in the task bar.
A green arrow wrapped around the blue X indicates an SE assignment is ready to be submitted. To
unassign an SE, click this icon.
Step 5 Click Submit to save the settings.
A green circle with a check mark indicates a device group is assigned to this SE. To unassign the device
group, click this icon, or click the Unassign All Device Groups icon in the task bar. Click Submit to
save the changes.
Note From this point forward, the beginning steps in the procedures are combined into one step using notation
similar to the following: Devices > Devices Assignments > Device Groups.
Configuring Bandwidth for Replication and Ingest
The bandwidth used for replication and ingest is determined by the settings in the Default Bandwidth
and the Scheduled Bandwidth pages. The replication configuration pages consist of the following:
• Default Bandwidth