Specifications

4-9
Cisco Internet Streamer CDS 2.0-2.3 Software Configuration Guide
OL-13493-04
Chapter 4 Configuring Devices
Configuring the Service Engine
Step 5 Click Submit to save the settings.
Assigning Devices to Device Groups
You can assign devices to device groups in three ways:
• Through the Device Group Assignment page
Set Default
Coverage Zone
File
When checked, which is the default setting, a default Coverage Zone file is
generated with the SE serving the local subnet it resides on. The coverage zone is
a CDS network-wide mapping of client IP addresses to SE IP addresses that should
respond to client requests. For more information, see the “Coverage Zone File
Registration” section on page 6-9.
The default coverage zone can be disabled and you can create and assign custom
coverage zones using the Coverage Zone file import or upload.
Uncheck the Set Default Coverage Zone File check box to use a user-defined
Coverage Zone file that was imported or uploaded.
Location Lists all the locations configured for the CDS.
Use SE’s primary
IP address
Enables the CDSM to use the IP address on the primary interface of the SE for
management communications.
Note If the Use SE’s primary IP Address for Management Communication
check box is checked and the Management Communication Address and
Port are configured, the CDSM uses the SE’s primary IP address for
communication. If communication attempts to the primary address fail, the
CDSM tries the configured IP address and port.
Note Do not check the Use SE’s primary IP Address for Management
Communication check box if you want to separate management and
streaming traffic. Instead, use the Management Communication Address
and Port fields to specify where management traffic should be sent.
Management
Communication
Address
Manually configures a management IP address for the CDSM to communicate with
the SE.
Note This is a Release 2.1 feature.
Manual configuration of the management IP address and port are used when using
port channel configuration to separate management and streaming traffic. For more
information about port channel configuration see the “Configuring Port Channel
and Load Balancing Settings” section on page 4-62 and the “Configuring Port
Channel” section on page E-1.
Management
Communication
Port
Port number to enable communication between the CDSM and the SE.
Note This is a Release 2.1 feature.
Comments Information about the settings.
Table 4-2 Device Activation Fields (continued)
Field Description