Specifications

4-5
Cisco Internet Streamer CDS 2.0-2.3 Software Configuration Guide
OL-13493-04
Chapter 4 Configuring Devices
Configuring Device Groups
For information about baseline groups, see the “Baseline Groups” section on page 2-3.
Step 6 To customize the left panel menu for this device group, click the Select pages to hide from the menu
for this device group arrow, and check the pages you want to hide. To collapse these settings, click the
arrow again.
Use this feature to remove from view any configuration pages that you do not need for the device group.
Step 7 In the Comments field, enter any information about the device group.
Step 8 Click Submit to save the settings.
If you are editing this device group, you can view a list of all settings configured for this device group
by clicking the Pages configured for this device group arrow. To collapse this information list, click
the arrow again.
To delete a device group, click the Trash icon in the task bar.
Step 9 To assign SEs to the device group, choose Assignments > Devices. The Assignment table is displayed
listing all SEs in the CDS.
Step 10 Click the Assign icon (blue cross mark) next to each SE name you want to assign to this group.
To assign all SEs, click Assign all Service Engines in the task bar.
Step 11 Click Submit to add the selected SEs to the device group.
To remove an SE from the device group, click the Unassign icon (green check mark) next to the name
of the SE, and click Submit.
To remove all SEs from the device group, click the Unassign all Service Engines icon in the task bar,
and click Submit.
Note All configuration settings for a device group can be configured on an individual SE as well. All other
configuration pages for a device group are covered in the “Configuring the Service Engine” section on
page 4-6.
Device Group Overlap
If you want the ability to assign a device to more than one device group, you must enable device group
overlap. Device group overlap is enabled by default.
To enable or disable device group overlap, do the following:
Step 1 Choose System > Configuration. The Config Properties page is displayed.
Step 2 Click the Edit icon next to the DeviceGroup.overlap property. The Modifying Config Property page is
displayed.
Step 3 To enable device group overlap, choose true from the Value drop-down list.
To disable device group overlap, choose false from the Valu e drop-down list.
Step 4 Click Submit to save the settings.