Specifications

3-4
Cisco Internet Streamer CDS 2.0-2.3 Software Configuration Guide
OL-13493-04
Chapter 3 Getting Started
Activating and Synchronizing the Devices
Note If the device you want to activate is not listed in the Devices Table, restart the CMS for that device by
telneting to it and entering no cms enable followed by cms enable in global configuration mode.
Step 3 Click Activate in the Device home page. The Location dialog box is displayed (Figure 3-3).
Figure 3-3 Device Home Page—Location Dialog Box
Step 4 Create or choose a location. To activate an SE, you need to assign it to a location.
Because the standby CDSM is global to the CDS network, it does not need to be assigned to a location.
You have the following options in creating or choosing a location:
a. If you have already created locations, you can choose a location from the Location drop-down list.
b. To create a default location, which can be edited later, check the Create a New location check box.
A default location is created with the following name: <SE-name>-location. From the Parent of the
New Location drop-down list, choose a parent for this location.
For information about creating locations, see the “Configuring Locations” section on page 4-1.
Step 5 Click Apply and Activate.
The Status of the device shows “pending” until the device is fully activated. This may take a few minutes.
Step 6 To display the top-level Table of Contents, click the Show All button above the Contents pane.
Step 7 From the left-panel menu, select General Settings > Network > NTP. The NTP Settings page is
displayed.
Step 8 Check the Enable check box and enter the IP address or hostname of each NTP server. Use a space to
separate each server.
Step 9 Click Submit to save your settings.
The activation and NTP server settings must be completed for each SE, SR, and standby CDSM.