Specifications

8-12
Cisco Internet Streamer CDS 2.0-2.3 Software Configuration Guide
OL-13493-04
Chapter 8 Maintaining the Internet Streamer CDS
Replacing a Device
Step 4 To execute your request, click OK. The device is removed from the CDSM.
Step 5 If possible, access the device CLI to deregister the device.
Step 6 In the CLI, enter the cms deregister force command.
Note You must use the cms deregister force command after deleting a device in the CDSM. This is
because once the device has been deleted, the CDSM no longer has a record of the device.
Step 7 To add the device back in to the CDS network, reregister the device with the CDSM by using the cms
enable command in global configuration mode.
Deleting a Warm Standby CDSM
You can delete a warm standby CDSM from the CDS network at any point after you have registered the
device and before the device has come online as the primary CDSM. Once the device has been called
into use as the primary CDSM, however, you cannot delete it by using the CDSM.
Delete a warm standby CDSM when the device is experiencing unresolvable problems or when its
network address or configuration has changed and you need to add the device back to the CDS network
by using its new address and configuration information.
To delete a warm standby CDSM, do the following:
Step 1 Log in directly to the CDSM CLI, and enter the cms deregister command.
If for some reason the deregistration fails, you can force the deregistration by using the cms deregister
force command.
Step 2 From the CDSM GUI, choose Devices > Devices.
The browser refreshes, listing the CDSMs on your CDS network. The warm standby CDSM is identified
as Standby.
Step 3 Click the Edit icon next to the name of the warm standby CDSM. The Device home page is displayed.
Step 4 From the left-pane menu, choose Device Activation. The Activation page is displayed.
Step 5 In the task bar, click the Trash icon. You are prompted to confirm your decision.
Step 6 To execute your request, click OK.
Replacing a Device
The procedure to replace a device in the CDS is different depending on the type of the device being
replaced. This section covers the following procedures:
• Replacing a CDSM
• Replacing an SE or SR