Specifications

4-88
Cisco Internet Streamer CDS 2.0-2.3 Software Configuration Guide
OL-13493-04
Chapter 4 Configuring Devices
Configuring the Service Router
Step 5 Click Submit to save the settings.
Configuring Routing Settings
To configure the SR routing method, do the following:
Step 1 Choose Devices > Devices > Routing Settings. The Routing Settings page is displayed.
Step 2 Enter the settings as appropriate. See Table 4-47 for a description of the fields.
Coverage Zone
File
To have a local Coverage Zone file overwrite the CDS network-wide Coverage
Zone file, choose a file from the Coverage Zone drop-down list. See the
“Coverage Zone File Registration” section on page 6-9 for information about
creating and registering a Coverage Zone file. Otherwise, choose None.
Use SR’s primary
IP address
Enables the CDSM to use the IP address on the primary interface of the SR for
management communications.
Note If the Use SR’s primary IP Address for Management Communication
check box is checked and the Management Communication Address and
Port are configured, the CDSM uses the SR’s primary IP address for
communication. If communication attempts to the primary address fail, the
CDSM tries the configured IP address and port.
Note Do not check the Use SR’s primary IP Address for Management
Communication check box if you want to separate management and
streaming traffic. Instead, use the Management Communication Address
and Port fields to specify where management traffic should be sent.
Management
Communication
Address
Manually configures a management IP address for the CDSM to communicate with
the SR.
Note This is a Release 2.1 feature.
Manual configuration of the management IP address and port are used when using
port channel configuration to separate management and streaming traffic. For more
information about port channel configuration see the “Configuring Port Channel
and Load Balancing Settings” section on page 4-62 and the “Configuring Port
Channel” section on page E-1.
Management
Communication
Port
Port number to enable communication between the CDSM and the SR.
Note This is a Release 2.1 feature.
Comments Information about the settings.
Table 4-46 Service Router Activation Fields (continued)
Field Description