Specifications

4-55
Cisco Internet Streamer CDS 2.0-2.3 Software Configuration Guide
OL-13493-04
Chapter 4 Configuring Devices
Configuring the Service Engine
Configuring an Access Control List
To configure an access control list (ACL) for group authorization, do the following:
Step 1 Choose Devices > Devices > General Settings > Authentication > Access Control List > Configure
Access Control List. The Access Control List Table page is displayed.
Step 2 Click the Create New icon in the task bar. The Configure Access Control List page is displayed.
To edit a group, click the Edit icon next to the name you want to edit.
Step 3 Enter the settings as appropriate. See Table 4-26 for a description of the fields.
Step 4 Click Submit to save the settings.
To delete a group, click the Trash icon in the task bar.
Step 5 From the left-panel menu, choose Enable Access Control List. The Enable Access Control List page is
displayed.
Step 6 Check the Enable Access Control List check box and click Submit.
To move a group up or down in the Access Control List table, click the Up arrow or Down arrow in the
Move column.
The ACL can be applied from the SE or from a device group. The source of the currently applied settings
is shown in the Access Control List Table page.
Scheduling Database Maintenance
The database maintenance runs at the scheduled time only when the following three conditions are
satisfied:
• The last vacuum process happened more than 30 minutes in the past.
• The percent increase in disk space usage is greater than 10 percent.
• The available free disk space is greater than 10 percent of the total disk space.
If any of these conditions are not satisfied, the database maintenance does not run at the scheduled time.
To schedule a database cleaning or reindexing, do the following:
Step 1 Choose Devices > Devices > General Settings > Database Maintenance. The Database Maintenance
Settings page is displayed.
Table 4-26 Access Control List Fields
Field Description
Action Whether to permit or deny access for this group.
Group Name If this action is for all groups, choose Any Group Name.
If this action is for a specific group, choose Enter Group Name and enter
the group name in the field.
Change Position To change the order of this group in the access control list, which is
displayed in the Access Control List Table page, click Change Position.