Specifications

4-18
Cisco TV CDS 2.5 ISA Software Configuration Guide
OL-24788-01
Chapter 4 Configuring the CDS
System Level Configuration
To configure the Stream Destination, do the following:
Step 1 Choose Configure > System Level > Stream Destination. The Stream Destination page is displayed
(Figure 4-8).
Note If Bulk Configuration is enabled, the Configuration File Location field is displayed, along with
the Action on Import option, and the Browse and Import buttons.
To import a Bulk Configuration XML file, click Browse to locate the file, select Add for the
Action on Import, then Import to import the file. The status of the import is displayed in the
left panel.
To delete the configurations defined in the Bulk Configuration XML file, click Browse to locate
the file, select Delete for the Action on Import, then Import. All the subnets defined in the Bulk
Configuration XML file are deleted and the status is displayed in the left panel.
For information on enabling the Bulk Configuration feature, see the “Bulk Configuration”
section on page F-5. For information about creating a Bulk Configuration file for Stream
Destination, see the “Creating Stream Destination Bulk Configuration Files” section on
page B-9.
Step 2 From the Subnet drop-down list, choose enter new.
To edit a subnet, choose the subnet from the Subnet drop-down list.
Figure 4-8 Stream Destination Page
Step 3
Enter the subnet address and subnet mask and click Submit.
Note If network address translation (NAT) is used for the STBs, be sure the IP subnet reflects the
public, routeable IP address for the NAT device, not the internal private IP address of the STB.